Home Up Contents Clearance Search Map About Us

Pond Supplies

Pond Care
Pond Gallery
Pond Pictures
Pond Kits
Pond Skimmers
Pond Filters
Pond Pumps
Pond Lights
Pond Parts
Pond How To

We carry everything you need to build a beautiful pond, fountain or waterfall in your home or garden. We also carry hard goods such as flagstone, moss covered rocks, weathered limestone, and ledge rock.

Turn your Pool into a Pond!

Bring us your ideas and we will help you figure out what you need and how much it will cost to build. It's easier than you think and a lot of fun.

Visualize the finished product and start planning what you need. After digging out the hole to be used for your pond you will want to place a 1" layer of Brick Sand in the bottom and up the sides of your pond before placing fabric cloth to protect and cushion the liner from the native sub-soil. Filter cloth is a felt like material in white or black as shown on the top right roll. Next comes the pond liner which is available in 10, 15, 20 or 25 foot widths in rolls up to 100' long. We recommend 45Mil EPDM rubber liner for it's strength, flexibility and long term duration. Up to 25 years versus vinyl or plastic which won't last nearly as long. It's fish friendly too! Rubber liner is usually folded into 5' widths on the roll as shown on the bottom two rolls above.
For a small pond you might decide that just a small fountain sprinkler sitting in the pond is all you require for water movement. Notice that these Cyprio pumps have both a flow control and built in tee which can be used to operate a small statuary or water feature.
If you plan on having a waterfall feature, it is advisable to use a pump which can handle the amount of water flow you will desire including the things that you don't think about up front. New hoses and pumps as you see them demonstrated in a store always seem to have wonderful flow - until you get them home and use them for 3 or 4 months. The hoses will get a film of algae on the inside, the pumps will always have some degree of dirt or blockage which will reduce the flow. Yes you are supposed to keep the pump clean at all times but we all know that doesn't happen. No excuse though if you burn out the pump because there was NO water flow. The manufacturers know better!

The farther and higher the pump has to push the water the less pressure you end up with. A 1740 gallon per hour pump (shown here) has a maximum head of 20'. That means if you were to connect a hose on this pump and run it straight up for 20' you would get virtually no water coming out the top. But at 5' you would get about 1200 gallons per hour.

Vinyl Tubing is used to connect pumps to water features or even to a waterfall.

It is available in standard sizes including 

3/8"
1/2"
3/4"
1"
1-1/8"
1-1/4"
We also carry fittings, adapters, reducers and flow controls.

Non-Kink tubing is more expensive than plain vinyl tubing but has some distinct advantages. It won't easily kink or crush, which means you can pile dirt and and rock (within reason) on top of it without having it get crushed flat. This is very good for running from the main pump to the waterfall feature.
A Bio-filter is a good method of filtering your pond using mother nature. Water enters through the bottom from a pump in the pond. The container is filled with lava rock, pebbles or bio-balls and topped off with plants all of which help strain and clean the water as it slowly re-circulates back into the pond over the lip. They are 34" across and 11" deep.
Another method of filtering is using a sealed pressurized filter which is placed in the ground just outside of your pond. They provide full mechanical and biological filtration. They are also available with an internal UV (Ultra-Violet) lamp assembly which helps to reduce the levels of algae in the water. They are available in sizes to handle 250, 500 and 1000 gallon ponds. 
A low voltage light can be placed in the water for great night lighting effect. Each lamp comes with 4 colored lenses (blue, green, yellow and red) or can be used as a spotlight in natural.

 

pondliner Fountain pumps Waterbell fountain pond tubing Submersible lights
pond liner pumps fountains tubing light kits

Rigid ponds are available in a wide selection of sizes to help you quickly create a water feature.

Rigid Ponds

Home ] Up ] Pond Care ] Pond Gallery ] Pond Pictures ] Pond Kits ] Pond Skimmers ] Pond Filters ] Pond Pumps ] Pond Lights ] Pond Parts ] Pond How To ]
Celebrating 42 Years of
Service Excellence
We are located in Burlington, Ontario, Canada (905) 634-7707 for more contact information click here.
Send mail to Info at capbrick@msn.com with any questions or comments about this web site
Designed, Created  and Administered by Verne Gorven, Copyright © 1998-2008  C-A Building Products Limited
Last modified: March 14, 2008    You are visitor # Hit Counter in 2008